These are the motion blur parameters that belong to the camera, as opposed to the ones in the rendering options, that define instead the times at which the scene is evaluated.

By default, the shutter start/end times are taken from the rendering options. You can, however, override them by enabling Override Geometry Shutter.

 

Shutter Type

The filtering applied to time samples. By default, this is a box filter, with all time samples having the same weight. A triangle (or "tent") filter is also available which produces smoother trails.

Arnold supports custom shutter shapes with the shutter curve camera parameter. You can define as many points as required. Coordinates increase from 0 (corresponding to the shutter_start) to 1 (corresponding to the shutter_end). Values in the vertical axis must be non-negative, and it is not recommended to enter values above 1. The values are linearly interpolated between each point. In the examples below, you can see the effect different curve shapes have on the motion blur trail of a sphere that has been key-framed moving from left to right.

Various custom camera shutter curve shapes

 

The example below shows a box moving from left to right with shutter curve enabled:

 

 

Rolling Shutter

Rolling Shutter is used to simulate the type of rolling shutter effect seen in footage shot with digital cameras that use CMOS-based sensors such as Blackmagics, Alexas, REDs, and even iPhones. This method is implemented by rolling (moving) the shutter across the camera area instead of the entire image area all at the same time. 

Without rolling shutter (rollover image).

With rolling shutter (rollover image).

 

The Rolling Shutter direction specifies the direction that the rolling shutter takes place. The default is 'off'' and can be set to 'top' (top to bottom being the most common scanning direction), 'bottom', 'left' or 'right'. 


Interesting effects can be achieved when combining motion blur 'length' with rolling shutter:

Motion blur 'length' from 0 to 2

Rolling Shutter Duration

With this parameter, it is possible to control the duration of exposure of the scanlines in a rolling shutter camera. Valid values for this parameter are in the 0 to 1 range, where a value of 0 gives you an instantaneous exposure of each scanline (the default value and the rolling shutter's previous behavior), and a value of 1 exposes every scanline for the entirety of the camera's shutter interval (the same result that a camera without rolling shutter would give).


 

 

  • No labels
Privacy settings / Do not sell my personal information / Privacy/Cookies